ASSEMBLY INSTRUCTIONS ASSEMBLY RATING The Assembly Rating is a 5-point system that show the degree of effort needed in assem bling a specific product(with 1 being easy and 5 being difficult). For most products, two per sons are recommended.
Thank you for your purchase! We hope you will enjoy your new product for many years to come. Our commitment to providing quality products does not simply end when a purchase is made. We stand behind our products and will provide any support needed in order for you to fully enjoy your purchase. Your satisfaction is the greatest recognition we could have." '. \ Because we value your trust ih~our COmpany, we 'will do our best torneetyour , service expectations. Should you have' any assembly re.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST; CORRECT ASSEMBLY AND P.ROPER MAINTENAI~CEARE NECESSARY. PLEASE fOLLOWTHE INFORMATION PROVIDED BELOW TO FULLY ENJOY ypUR FURNITURE,. .. BASIC ASSEMBLY TECHNIQUES 1 It is highly recommended that the assembly should be done near the area of it$ intended l~tion.Make slJ~you'have enough space to move. around during the assembly: . Use cardboard or carpet area when Position each part correctly and insert .
PRE-ASSEMBLY INTRODUCTION Unless you are particularly adept at assemblingflat-packlknock-down 'furniture, we understand building.ready- -assemble furniture can be a· frustrating experience for some. To help avoid confusion and to make. the assembly process quicker and smoother, we have provided some helpful tips. Before youbegin the assembly, please read the following: 1. 2. 3. 4. 5. 6.. 7. Due to the size and/or weight on most of theready-to-assemble furniture, .
Note: Every cam lock bolt musthave a cam lock connector in order to fasten the parts together. (1) . .. Align the cam connector with its side opening(or arrow} pointing to the small . drilled hole. Secure the threaded end ofthe cam bolt by using a·. screwdriver. Turn right (clockwise)to tighten. (2) (3) Insert the cam lock 'bolt into the pre-drilled hole above·the cam connector. Two parts should fit snugly against each other. ~ (4) Turn the cam connector with ~ .
ASSEMBLY INSTRUCTIONS . STEP1 , Hardware #1 = 32pes Hardware #6 = 2pes Hardware #12 = 4pes . 7 \\ . ··~r----G)-2-.-·.~-·.·~ ·4··~ o·~ X2 Ir~ ~CD o ~ ... .~ c ~ ... ~ l~ '" '" • X2 ~:r·.e.i X2 STEP2 Hardware #4 = Spes i· U X2 CD ~ Paae7 .1;b.
ASSEMBLY INSTRUCTIONS ,STEP3 Hardware #2 = 16pes Hardware #3 = 16pes - .. X2 X2 STEP4 Hardware #13 =8pes Hardware #14 = 8pes D ............
STEP5 Hardware #3 = 12pcs Hardware #4 = 12pcs X2 STEP6 Hardware #2= 4pcs Hardware #3 = 4pcs • Page 9
ASSEMBLY INSTRUCTIONS STEP7 Hardware #2 = 4pes STEPS Hardware #2 = Spes Hardware #3 4pes Hardware #16 4pes = =
ASSEMBLY INSTRUCTIONS STEP9 Hardware #5 = 2pcs Hardware #8 = 2sets Hardware #9 = 2pcs Hardware #10= 2pcs Hardware #11= 4pcs . .. ~® S"rEP10 Hardware #7 ::: 4pcs Make sure the product is rested on a 'flatsurface and does not feel loose or wobbly. If it does, double check that the bolts/screws are secured and properly tightened.
