User Manual

TRIPLE-ACTION HANDLE ASSEMBLY INSTRUCTIONS

Needle Knob

Set Screw

Allen Wrench

Needle Knob Spring

AIRBRUSH NOT INCLUDED

Needle Chucking

Knob

Triple Action

Barrel

1. Remove handle. (image 1) 5. The needle should extend

just past the end of the

handle. (image 5)

2. Remove needle chucking nut.

(image 2)

3. GENTLY push on the back of the

needle to make sure it is seated

into the nozzle. (image 3)

4. Screw the Triple Action Barrel

onto the airbrush body. Tighten

lightly. (image 4)

6. Place the Allen wrench into

the set screw in the side of the

Needle Knob. (image 6)

7. Slide the Needle Knob over

the needle in the airbrush.

(image 7)

8. Slide the Needle Knob over the

needle until the side of the Allen

wrench comes into contact with

the end of the Triple-Action Barrel.

(image 8) Note: If the Allen wrench

cannot touch the end of the

Triple-Action Barrel, unscrew

the set screw one turn to allow

the Needle Knob to move forward

and seat properly.

PAGE 1
TRIPLE-ACTION HANDLE ASSEMBLY INSTRUCTIONS AIRBRUSH NOT INCLUDED Needle Chucking Knob Needle Knob Needle Knob Spring Allen Wrench Triple Action Barrel Needle Knob Set Screw 1. 1. Remove handle. (image 1) 5. 5. The needle should extend just past the end of the handle. (image 5) 2. 2. Remove needle chucking nut. (image 2) 6. 6. Place the Allen wrench into the set screw in the side of the Needle Knob. (image 6) 3. 3.
PAGE 2
9. 9. Firmly tighten the set screw by turning the Allen wrench. Take care not to bend the needle inside. The Needle Knob is now attached to the needle in the correct position. 12. 10. Pull the Needle Knob with the attached needle out the back of the airbrush. (image 9) 10. 11. 11.