User's Manual

TR-800 EVALUATION KIT USER GUIDE V1.0 CONFIDENTIAL
All specifications are correct at the time of release. iWOW Connections owns the proprietary rights to the information contained herein this
document. It may not be edited, copied or circulated without prior written agreement by iWOW Connections Pte Ltd. iWOW Connections Pte Ltd
reserves the right to, at any time modify the document content without prior notice.
© 2005 iWOW Connections Pte Ltd
11
7. To ensure that the correct communication parameter has been set-up, click on its Properties.
Ensure the parameters below are correct:
 Port Speed/Baud Rate: 115200
 Data Bits: 8
 Parity: None
 Stop Bit: 1
 Flow Control: Hardware
4.4 Establish a GSM Dial-up Connection
After TR800 is set up as a Serial Modem as shown in previous section, you can then create a GSM
dial-up connection by the following steps:
1. Go to Control Panel>Network
Connections.
Run New Connection Wizard.
Click Next.
2. Select Connect to the Internet.
Click Next.
Figure 17
Figure 18