User's Manual

Communication Machinery Corporation (CMC)
B-2 Rev #/Date: 2.0.0 Beta/07.17.03
###########################################################
###########################################################
###########################################################
###########################################################
###########################################################
###########################################################
###########################################################
###########################################################
###########################################################
#
done
1007441 bytes
CMC_EE ->
8) When the transfer is complete, use the "ls" command to verify
that the size of the file in Flash is the same number of bytes as the
file on the FTP server/command PC.
CMC_EE -> ls
9) At the CMC_EE-> prompt, type the following command to move
the file and use the correct boot name.
CMC_EE -> mv EE22NEW.SYS EE22.SYS
10) When the move is complete, use the "ls" command to verify the
file has been moved with the correct name.
CMC_EE -> ls
11) Use the "reboot" command to reboot the EmulationEngine and
to activate the new software.
CMC_EE -> reboot
After reboot, you must reestablish the telnet session in order to log
back in to the CLI. If the CLI displays the message “This
EmulationEngine has not been Node Locked” after you enter the
EE login name and password, see “Missing Key File” in Chapter 9.
Troubleshooting.