User's Manual

EmulationEngine 11a/b/g User's Guide
Rev #/Date: 2.0.0 Beta/07.17.03 C-1
APPENDIX C: Cable Pin Assignments
Standard Ethernet Cable
A straight cable can be used to connect the Command PC to a hub
and the hub to the EmulationEngine For a straight cable; the
wires match one for one. This cable is not provided.
Pin 1: Rx+
Pin 2: Rx-
Pin 3 : Tx+
Pin 4 : Not Used
Pin 5 : Not Used
Pin 6 : Tx-
Pin 7 : Not Used
Pin 8: Not Used
Ethernet Cross-Over Cable
A cross-over cable must be used to connect the Command PC
directly to the EmulationEngine. This cable is provided.
Pin 1: Rx+
Pin 2: Rx-
Pin 3 : Tx+
Pin 4 : Not Used
Pin 5 : Not Used
Pin 6 : Tx-
Pin 7 : Not Used
Pin 8: Not Used
RJ-45 Connector