User's Manual

Communication Machinery Corporation (CMC)
2-2 Rev #/Date: 2.0.0 Beta/07.17.03
Back Panel
Connectors
10/100 Ethernet Connector: This connector provides 10/100
Mbps connectivity to a wired Ethernet LAN. It is used to connect a
command PC to the EmulationEngine.
Serial Port: This connector can also be used to connect a
command PC to the EmulationEngine. The configuration of the
serial port is: 9600 bps, 8 data bits, no parity, 1 stop bit, and no
flow control
AC Power Connector: This connector is used to connect the
EmulationEngine to the provided power supply.
Antennas
There are two antennas on the back of the device. The system
chooses the best antenna for transmit and receive. The antennas
can be swiveled 180 degrees and angled up or down to optimize
signal gain.
Reset Button
A recessed reset button is located between the Ethernet Connector
and Power Supply Connector on the back of the unit. It can be
used to perform a hard reset of the EmulationEngine. To perform
a hard reset, use a paper click to press the reset button.