User's Manual
Table Of Contents
- The Command Line Interface (CLI)
- CLI Usage Notes
- User Log-In
- User Log-Off
- CLI Commands
- System Under Test Commands
- Virtual Station Set-Up & Control Commands
- Statistics File Commands
- Event Log Commands
- EmulationEngine Commands
- association (get)
- channel (get)
- config (get)
- countrycode (get/set)
- date (set)
- eemac (get/reset/set)
- eemask (get/set)
- eestatus (get)
- exec
- factorydefault (set)
- features (get/set)
- fragmentthreshold (get/set)
- frequency (get)
- ftp
- gateway (get/set)
- hardware (get)
- help
- history
- hwtxretries (get/set)
- ipaddr (get/set)
- ipmask (get/set)
- key (del/get/set)
- keyentrymethod (get/set)
- login (get/set)
- password (set)
- ping
- power (get/set)
- quit
- rate (get/set)
- reboot
- rtsthreshold (get/set)
- sntpserver (get/set/clear)
- station (get)
- systemname (clear/get/set)
- telnet (get/set)
- time (set)
- timeofday
- tzone (get/set)
- uptime (get)
- version (get)
- 802.11b/g Commands
- Administrative Mode Commands
- Example Configurations
- CLI Editor
EmulationEngine 11a/b/g User's Guide
Rev #/Date: 2.0.0 Beta/07.17.03 6-17
CMC_EE ->
reset group
This command resets all virtual stations in a group to the
Initialized state and clears all group statistics counters.
reset group <id>
<id>: Group Number (1...64)
Example:
CMC_EE -> reset group 1
5 vSTAs reset
CMC_EE ->
save group stats
This command saves statistics information in a file for all virtual
stations in a specified group. Each virtual station in the group is
saved to its own file. The file will be stored in the /Statistics
subdirectory and named "Vsta#Stats.dat" (where "#" is the virtual
station ID).
save group <id> stats
<id>: Group ID (1...64)
save group summary
This command saves cumulative summary statistics in a file for all
virtual stations in one or all groups. Each group is saved to its
own file. The file will be stored in the /Statistics subdirectory and
named "Grp#Summ.dat" (where "#" is the group ID).
save group <id> summary
<id>: Group ID (1...64) or "all". If <id> is set to "all" (i.e., save
group all summary), summary statistics are saved for all virtual
stations in all groups.
set group
This command modifies configuration parameters for all virtual
stations in a specified group.
set group <id> <attribute> <value>
<id>: Group Number (1...64)
<attribute>: authentication, cipher, count, csmode, encryption,
keyindex, lp, mode, retry, size, target, timeout.
<value>: Depending on the <attribute>, set <value> to one of the
following.
<attribute> <value>
authentication Authentication mode: open-system or shared-key
cipher Cipher mode: wep
count Ping Count: 0...2,147,483,647