User's Manual
Table Of Contents
- The Command Line Interface (CLI)
- CLI Usage Notes
- User Log-In
- User Log-Off
- CLI Commands
- System Under Test Commands
- Virtual Station Set-Up & Control Commands
- Statistics File Commands
- Event Log Commands
- EmulationEngine Commands
- association (get)
- channel (get)
- config (get)
- countrycode (get/set)
- date (set)
- eemac (get/reset/set)
- eemask (get/set)
- eestatus (get)
- exec
- factorydefault (set)
- features (get/set)
- fragmentthreshold (get/set)
- frequency (get)
- ftp
- gateway (get/set)
- hardware (get)
- help
- history
- hwtxretries (get/set)
- ipaddr (get/set)
- ipmask (get/set)
- key (del/get/set)
- keyentrymethod (get/set)
- login (get/set)
- password (set)
- ping
- power (get/set)
- quit
- rate (get/set)
- reboot
- rtsthreshold (get/set)
- sntpserver (get/set/clear)
- station (get)
- systemname (clear/get/set)
- telnet (get/set)
- time (set)
- timeofday
- tzone (get/set)
- uptime (get)
- version (get)
- 802.11b/g Commands
- Administrative Mode Commands
- Example Configurations
- CLI Editor
EmulationEngine 11a/b/g User's Guide
Rev #/Date: 2.0.0 Beta/07.17.03 6-49
communicate. When CTS protection mode is enabled (mode =
always or auto), the EmulationEngine will use RTS/CTS (as
defined by “ctstype”) to communicate with an 11b device.
get ctsmode (11g only)
This command displays the current CTS protection mode setting:
get ctsmode
Example
CMC_EE -> get ctsmode
CTS Mode: AUTO
CMC_EE ->
set ctsmode (11g only)
This command sets CTS protection mode:
set ctsmode <mode>
<mode>: none = never use CTS protection, always = always use
CTS Protection, or auto = use CTS protection when an 802.11b
device is detected.
ctsrate (get/set)
get ctsrate (11g only)
This command displays the current CTS rate:
get ctsrate
Example:
CMC_EE -> get ctsrate
CTS Rate: 11 Mbps
CMC_EE ->
set ctsrate (11g only)
When CTS mode is enabled (always or auto), this command sets
the rate at which RTS/CTS frames are transmitted:
set ctsrate <rate>
<rate>: 1, 2, 5.5, or 11 Mbps.
ctstype (get/set)
get ctstype (11g only)
This command displays the current CTS type setting:
get ctstype
Example:
CMC_EE -> get ctstype
CTS Type: CTS-ONLY
CMC_EE ->
set ctstype (11g only)
When CTS mode is enabled (always or auto), this command sets
the CTS type: