User's Manual

EmulationEngine 11a/b/g User's Guide
Rev #/Date: 2.0.0 Beta/07.17.03 6-53
<filename>: The name of an image file (.sys) to use to boot the
EmulationEngine.
<hostname>: If <source> is ethernet, the name of the host
computer where <filename> resides.
<hostIP>: If <source> is ethernet, the IP address of the host
computer where <filename> resides.
<username>: If <source> is ethernet, the username required to
access <hostname>.
<password>: If <source> is ethernet, the password required to
access <hostname>.
Examples:
CMC_EE -> boot flash EE22.SYS
boot device : tffs:
unit number : 0
processor number : 0
file name : /fl/EE22.SYS
inet on ethernet (e) : 10.1.35.18
inet on backplane (b): 255.255.255.0
host inet (h) : 10.1.35.67
gateway inet (g) : 10.1.35.1
user (u) : u=anonymous
ftp password (pw) : password
flags (f) : 0x0
other (o) : dp
CMC_EE -> boot flash
boot device : tffs:
unit number : 0
processor number : 0
file name : /fl/EE22.SYS
inet on ethernet (e) : 10.1.35.18
inet on backplane (b): 255.255.255.0
host inet (h) : 10.1.35.67
gateway inet (g) : 10.1.35.1
user (u) : u=anonymous
ftp password (pw) : password
flags (f) : 0x0
other (o) : dp
CMC_EE ->
bootrom
This command can be used to update the EmulationEngine boot
ROM image.
bootrom
When you enter this command, you will be prompted to confirm
execution of this command:
Updating boot firmware with a flat binary file bootrom*.sys
This is a risky operation!
Are you sure (y/n)?