Information

FEATURES AND BENEFITS

CONTENTS OF DELIVERY

TECHNICAL SPECIFICATIONS

CAN-CR110/FO

CAN / CAN FD repeater with screw terminals

and fiber optic connector

The CAN-CR110/FO is used for galvanic isolation of two segments of a CAN / CAN FD network. As

a special feature, the repeater separates a defective segment from the rest of the network,

allowing the remaining network to continue working. After the fault has been eliminated, the

segment is automatically switched back to the network. The galvanic isolation is provided for the

CAN / CAN FD segments as well as for the power supply.

Fiber optic enables transmission in areas with high electromagnetic disturbances



CAN and CAN FD interfaces in one device



Cost savings due to simple wiring



Increased system reliability



Almost no influence on real-time behavior



CAN-CR110/FO



User manual



Display Transmit and defective segment (two duo LEDs, one for

each segment), Power (one LED)

CAN bus interface ISO 11898-2 with CAN choke. Two screw terminals.

CAN variant available with and without integrated CAN termination.

CAN bitrates Up to 1 Mbit/s

CAN FD bus interface ISO CAN FD and nonISO CAN FD

CAN FD bitrates Arbitration rate up to 1000 kBit/s, data rate up to 8000 kbit/s. The data rates are verified by

tests. User-defined bit rates are possible.

Attention: The maximum data rate can be exceeded depending on the concrete operating

conditions (cable length, settings made, remote stations,...), but it can also not be reached.

Delay typ. 300 ns (corresponds to ~60 m bus length) between the wire

connection of a FO Repeater through the fiber optic cable to the wire

connection of a second FO Repeater (not including the signal delay

time of the fiber optics, which is ~5 ns/m)

FO transmitter Broadcom HFBR 1404Z, 820 nm

FO receiver Broadcom HFBR 2402Z, 820 nm

PAGE 1
CAN-CR110/FO CAN / CAN FD repeater with screw terminals and fiber optic connector The CAN-CR110/FO is used for galvanic isolation of two segments of a CAN / CAN FD network. As a special feature, the repeater separates a defective segment from the rest of the network, allowing the remaining network to continue working. After the fault has been eliminated, the segment is automatically switched back to the network.
PAGE 2
FO line F-SMA connector; Multi-mode fiber optic line (only glass); recommended: 50/125 µm, 62,5/125 µm, also compatible with: 100/140 µm, 200 µm (pay attention to max. line length) Max. line length between 50/125 µm: 1500 m, 62,5/125 µm: 2000 m two FO repeaters Power supply 9-36 V DC, typ. 70 mA, max. 100 mA, through terminals Galvanic isolation 1 kV DC / 1 sec, 500 V AC / 1 min; CAN 1, CAN 2 and power supply are galvanically isolated from each other.