Datasheet

V1.0
www.ixxat.com
Page 1 of 2
The CAN repeater CAN-CR100 with two CAN/CAN FD interfaces
can be used to improve the load capacity of the CAN bus with
nodes, physical coupling of CAN/CAN FD bus systems or to insert
a galvanic isolation.
It creates the necessary flexibility to optimize the structure of
CAN/CAN FD networks and to free CAN networks from the
restriction to the bus structure. Since there is no integrated bus
termination resistor, it gives you flexibility in positioning
resistors for CAN termination.
The CAN repeater separates a defective segment from the rest
of the network, allowing the remaining network to continue
working.
FEATURES AND BENEFITS
ORDER NUMBER 1.01.0210.20200
Display 2 x CAN status LED (duo LED for communication and errors), Power LED
CAN channels (high speed) 2
CAN FD / CAN channels 2
CAN bus interface ISO 11898-2 with CAN choke, 2 x screw terminals
CAN bit rates Up to 1 Mbit/s
CAN FD bus interface ISO CAN FD and nonISO CAN FD
CAN FD bit rates Arbitration rate: up to 1000 kbit/s, data rate: up to 8000 kbit/s (verified
by testing). User defined bit rates are possible.
CAN bus termination resistors None
CAN/CAN FD transceiver MCP2562FD
Galvanic isolation 1 kV DC / 1 sec, 500 V AC /1 min; CAN 1, CAN 2 and power supply are
galvanic isolated against each other
CAN and CAN FD interfaces in one device
■
Cost savings due to simple wiring
■
Almost no influence on real-time behavior
■
Greater flexibility in CAN network design
■
Separates a defective segment, allowing the remaining network to
continue working
■
Increased system reliability
■
2 x CAN/CAN FD channels
■
Galvanic isolation
■
DATASHEET
CAN-CR100