Manual

Installation 10 (18)
6.2.1 Power Connector
Pin Allocation
Pin no. Signal
1 +9 V to +36 V DC
2 0 V
3
—
4
—
6.2.2 CAN Connector
Pin Allocation
Pin no. Signal
1
CAN high
2
CAN low
3 CAN GND
4
Shield
If a D-Sub 9 connector is used, observe the following pin allocation of the D-Sub 9 connector.
Pin no.
Signal
1
—
2
CAN low
3 CAN GND
4
—
5
—
6
—
7
CAN high
8
—
9
—
The shield of the CAN connector is connected to the ground via a 10 nF capacitor. The ground of
the device is connected to the DIN rail after mounting the device on the DIN rail. The ground of
the CAN connector (CAN GND) is connected via a 10 nF capacitor to the device ground.
For best noise immunity, ground the shields of the CAN cables.
CAN FD Repeater User Manual
4.01.0210.20000 1.4 en-US