Datasheet

ManualsBrandsIxxat ManualsAutomationCAN Umsetzer USB Embedded CAN bus 5 V DC 1 pc(s)

Table Of Contents

V1.0

www.ixxat.com

Page 1 of 3

The Ixxat USB-to-CAN V2 embedded with galvanic isolation is

installed via slot board and internal USB cable to a PC. It is an

uncomplicated and cost-efficient way to connect a computer

with an internal USB connection to a CAN bus network and can

be used for e.g. in the field of test, development, maintenance

or control applications.

Galvanic isolation reliably enhances the protection of the device

against damage to electronics caused by voltage peaks.

FEATURES AND BENEFITS

ORDER NUMBER 1.01.0282.12001

CAN channels (high speed) 1

CAN bus interface 1 x D-Sub 9, CiA standard pinning according to CiA 303-1

CAN bit rates 10 kbit/s to 1 Mbit/s

CAN bus termination resistors None

CAN controller Internal; CAN 2.0 A/B

CAN high-speed transceiver SN65HVD251D

Galvanic isolation 1000 V DC for 1 sec., 500 V AC for 1 min.

Time stamp resolution 150 - 250 μs

USB Interface USB 2.0 hi-speed (480 MBit/s), compatible with USB 1.1 and USB 3.x

USB connector Internal cable USB 2.0 Hi-Speed (480 Mbps) with 5 pin female connector

Microcontroller 32 Bit

RAM 192 kByte

Flash 512 kByte

Power supply +5 V DC (via USB port)

Cost-effective and extremely reliable

■

High-precision time-stamp accuracy

■

High data throughput combined with low latency

■

PC installation via slot board and internal USB cable

■

Galvanic isolation

■

High-speed CAN connection up to 1 Mbit/s with 9-pin D-Sub plug

■

Common driver interface for easy exchange of the PC interface type

■

Powerful programming interface for Windows (VCI) as well as for Linux

(socketCAN or ECI), QNX and VxWorks (ECI)

■

DATASHEET

USB-to-CAN V2 embedded

Summary of content (3 pages)

PAGE 1
DATASHEET USB-to-CAN V2 embedded The Ixxat USB-to-CAN V2 embedded with galvanic isolation is installed via slot board and internal USB cable to a PC. It is an uncomplicated and cost-efficient way to connect a computer with an internal USB connection to a CAN bus network and can be used for e.g. in the field of test, development, maintenance or control applications. Galvanic isolation reliably enhances the protection of the device against damage to electronics caused by voltage peaks.
PAGE 2
ORDER NUMBER 1.01.0282.12001 Power consumption 48 mA - max.
PAGE 3
SOFTWARE SUPPORT Drivers and programming interfaces A comprehensive and stable driver and software package is available for the USB-to-CAN V2 series, which can be downloaded free of charge from ixxat.com/support. The Ixxat driver packages for Windows (VCI) as well as Linux, INtime, RTX, VxWorks and QNX (ECI) also enable use in existing applications without software adaptation. The APIs for CANopen and SAE J1939 also support the USB-toCAN V2 device family.