User Manual

Setting up MIDI Control
Nectar’s Harmony Module allows you to trigger accompanying voices in real
time with a MIDI controller. In order to use the feature you must first route a
MIDI signal from your controller to Nectar 2 in your DAW. The instructions to set
this up vary, depending on your DAW, but the principle is the same; route a MIDI
track’s output to the input of the Nectar 2 plug-in. Below is a list of popular hosts
with steps to setup MIDI Control:
Pro Tools
1. Create a new Audio Track.
2. Find and choose "iZotope Nectar 2" as an insert effect on the track.
3. In the Advanced View of Nectar, engage the Harmony module and engage
the MIDI Control button.
4. Create a new MIDI Track.
5. In the MIDI Track's I/O section, assign the Input to your desired MIDI Input
Device.
6. In the MIDI Track's I/O section, assign the Output to "iZotope Nectar 2 1 A >
channel-1".
7. Record arm the MIDI track.
8. Playback audio, and use your MIDI Input Device to play and record har-
monies.
Cubase / Nuendo
1. Add a new Audio Track.
2. Find and choose "iZotope Nectar 2" as an insert effect on the track.
3. In the Advanced View of Nectar, engage the Harmony module and engage
the MIDI Control button.