User Manual

Pitch Editor Pitch Options
Pitch
Captured Data
Folder
Defines the directory in which all audio, layout and note data
captured in Nectar's Pitch Editor will be stored. Use the drop-
down arrow to change this to a new directory, reset to the
default folder, or explore currently existing data.
If you would like to change the Captured Data Folder after
capturing audio, you must copy the folder where this data is
stored to the new location you have specified. By default the
Captured Data Folder exists in the following locations:
Mac:
/Users/username/Documents/iZotope/Nectar 2/Captured
Pitch Data/
Windows:
\Users\Username\Documents\iZotope\Nectar 2\Captured
Pitch Data\
Piano Key Labels
Controls what notes or octaves will be displayed in the Pitch
Editor’s piano roll display.
Label Octaves
Controls whether or not notes will be displayed with their
octave numbering
Calibration A=
By default, all pitches will be based upon a standard A =
440Hz tuning reference. If your audio is not based on this
standard reference pitch, or has been moved slightly due to
analog tape recording, you can adjust Nectar's Reference
Pitch here.
Note Sensitivity
Use this control to adjust Nectar's behavior when 'accepting'
notes during capture. With a low note sensitivity, fewer note
changes will be recorded while a high sensitivity will result in
more notes being captured.