User Manual

General Functions
OZONE 7 | GENERAL FUNCTIONS
23
Input/Output Gain
The panel on the right side of the Ozone interface is the main input/output section for Ozone. This is
used for setting and monitoring gain levels going in and coming out.
Setting Input and Output
Gain You can adjust the input or output gain by sliding the faders with
the mouse, as well as clicking and using the mouse wheel.
Adjusting the Left and Right Channels Independently
By default, the left and right gain levels are linked; moving one moves
the other. You can adjust left and right gain independently by clicking on
the “lock” icon. You can also oset the two channels and then “relock”
them, so that later adjustments move both channels by the same
amount.
The faders will remember their oset, even if they are temporarily turned
up or down all the way, so that when you bring the faders back to the
middle the oset will be preserved.
Double-Click to Reset Faders
If the left and right faders are locked, double-clicking on either fader will
reset both of them to 0 dB. If the left and right faders are unlocked and
set at dierent levels, double-clicking a specific fader will reset it to 0 dB.
If the left and right faders are locked but had been previously been set
to dierent levels, doubleclicking on a fader will reset it to match the
level of the other fader. Another double-click will reset both faders
to 0 dB.
Setting the Scale of the Meters
You can further customize your metering by adjusting the scale of the input and output meters.
• Clicking the “(+)” sign below the meters will increase the zoom or resolution of the metering
scale.
• Clicking the “(-)” sign will decrease or zoom out the resolution of the metering scale.