User Manual

Mastering Modules
OZONE 7 | MASTERING MODULES
61
Multiband Controls
Like other multiband modules in Ozone, the controls for the Exciter can individually process each of
four frequency bands separately.
To access these controls, click the Crossover View icon on the upper left-hand side of the module
interface. The upper portion of the module interface will display the crossover points and frequency
bands, and the following controls will be accessible:
Selecting Crossover Points
Click and drag any of the three vertical white lines in the crossover display to select the frequency
range for each of the four bands.
Soloing a Band
Click on the “S” button on any of the frequency bands to hear that specific band only.
Bypassing a Band
Click on the graphical “power” button on any frequency bands to bypass the Exciter processing on
that specific band only. Processing for the other bands will remain enabled.
Post Filter View
Click the Post Filter View icon on the upper left-hand side of the module interface to switch to the post
filter view. The upper portion of the module interface will switch to a display showing a single high-
shelf filter.
Drag the filter node to adjust the frequency and gain of the high-shelf filter. This filter will be applied
to the entire Exciter module, allowing you to further adjust any high frequencies that have been
generated by the Exciter module.
Not only does the post filter view display the spectrum of the incoming signal, but it additionally
highlights particular frequencies being aected by the Exciter.
Exciter Controls
These controls are available for each band of the eggs cider.
Amount: This slider controls the amount of the harmonic excitation for the corresponding frequency
band.
Mix: This slider controls the mix of the excited signal with the original mix.
Mid/Side Controls
The Exciter module can operate in either Stereo or Mid/Side operation. See the Mid/Side Processing
section for more details.