SDS

Material Safety Data Sheet
For chemicals, coatings, and related materials
In compliance with OSHA 29 CFR 1910.1200
Date Prepared:
03-01-10
NAME: J-B Weld Co. INFORMATION PHONE NOS.
ADDRESS: 1130 Como St. DAY: [phone]
CITY/STATE: Sulphur Springs, Texas FAX: [phone]
ZIP CODE: 75483
Section I – Product
NAME: -%:HOG/LTXLG(SR[\:RRG – Part A HMIS HAZARD CODES
CLASS: Epoxy Resin Health: 2 (Moderate)
Flammability: 1 (Slight)
Reactivity: 0 (Minimal)
Personal Protective Equipment: H
Section II – Hazardous Ingredients
---Ingredient--- Percent C.A.S. Registry LEL Vapor Pressure
Material Description by Weight mm Hg @ 20°C
Epoxy Resin 100% **Trade Secret** n/a n/a
Section III – Physical Data
Boiling Range: n/a Freezing Point: n/a
Vapor Pressure: n/a mm@20°C Vapor Density: heavier than air
Specific Gravity: 1.04 H
2
0 Solubility: Negligible ( < 0.1%)
Evaporation Rate: Slower % Volatile by Volume: n/a %
(relative to n-butyl acetate)
Appearance and Odor: Clear Liquid, Slight Odor.
Section IV – Fire and Explosion Hazard Data
Flash point: >200°F Explosive Limits: LEL UEL (%V in air)
(Method used) Pensky-Martens n/a n/a
Flammability Classification
OSHA: Combustible Liquid – Class III B
DOT: Not regulated
Extinguishing Media:
Foam, Carbon Dioxide (CO
2
), Dry Chemical, Sand
Special Fire Fighting Procedures:
Wear protective clothing. Fight fire from a safe distance.
Close all valves to the area. Shut off all power to the area.
Emergency lights must be turned on.
Self-contained breathing apparatus is to be used.
Unusual Fire and Explosion Hazards: None