MSDS

2
MSDS Part #50112 Clearweld Epoxy Syringe page 2
Bis(dimethylaminomethyl)phenol
71074-89-0 0.55 %
1-(2-Aminoethyl)piperazine 140-31-8 7.00 %
Poly alkoxylated hydroxyalkyl thiol 101359-87-9 37.00 %
Benzyl Alcohol 100-51-6 3.00 %
4. FIRST AID:
EYES: Immediate and continuous irrigation with flowing water for at least 30 minutes is required.
Promptly seek medical attention if irritation develops
SKIN: Immediately wash skin with plenty of soap and water while removing contaminated clothing, and
shoes preferably under a safety shower. Seek medical attention immediately if irritation develops and
persists. Avoid prolonged or repeated contact to skin. Thoroughly clean shoes before reuse.
INGESTION: Do not induce vomiting. Give large amounts of water or milk if available and
transport to medical facility.
INHALATION: Remove to fresh air if effects occur. Consult a physician.
NOTE TO PHYSICIAN: Corticosteroid cream has been very effective and treating skin irritation.
5. FIRE FIGHTING MEASURES
Boiling Point: > 212 °F, (>100 °C)
Flash Point: > 285
0
F (> 140 °C)
Lower Explosion Limit not determined
Upper Explosion Limit not determined
Fire Fighting Equipment Alcohol resistant foam (PREFERRED) Use water, water spray, CO
2
dry chemical powder, dry sand, limestone powder
Fire Fighting Procedures Fire Fighters should wear SCBA to protect against the potentially acrid
fumes that could be generated during a fire. Cold water should be used to cool fire exposed drums, tanks
and other containers.
6. ACCIDENTAL RELEASE MEASURES
ACTION TO TAKE FOR SPILLS/LEAKS: VENTILATE AREA. EVACUATE unnecessary people from the
area. Large spill -- dike up and pump into appropriate containers. Small spill -use noncombustible
absorbent material/sand and shovel into suitable containers. Do not allow to enter water courses, sewers,
drains etc.
DISPOSAL METHOD: Large quantities should be recovered. Collect small quantities in waste metal
drums and seal for removal to an approved landfill, or incinerate in accordance with local, state, and
federal regulations. See also section 13
7. HANDLING AND STORAGE
Store between 0 and 50
0
C (32 -125
0
F) and avoid contact with skin and eyes. Do not store near acids.
Ground all transfer equipment. Hold bulk storage under a nitrogen blanket. This product should not come
in contact with copper or copper-bearing alloys. Good housekeeping procedures should be followed.
Avoid contact with eyes. Vapors may irritate eyes. Use only with good ventilation and PPE. Keep
container closed when not in use. Nitrogen purging of containers is ideal and good practice.
8. EXPOSURE GUIDELINE(S) AND CONTROLS: