SDS

Ingredient
Original IDLH
Revised IDLH
polymer
4-tert-butylphenyl glycidyl ether
Not Available
Not Available
Occupational Exposure Banding
Ingredient
Occupational Exposure Band Rating
Occupational Exposure Band Limit
4-tert-butylphenyl glycidyl ether
E
≤ 0.1 ppm
Notes:
Occupational exposure banding is a process of assigning chemicals into specific categories or bands based on a chemical's potency and the
adverse health outcomes associated with exposure. The output of this process is an occupational exposure band (OEB), which corresponds to a
range of exposure concentrations that are expected to protect worker health.
Exposure controls
Appropriate engineering
controls
Engineering controls are used to remove a hazard or place a barrier between the worker and the hazard. Well-designed engineering controls can
be highly effective in protecting workers and will typically be independent of worker interactions to provide this high level of protection.
Personal protection
Eye and face protection
Safety glasses with side shields.
Chemical goggles.
Skin protection
See Hand protection below
Hands/feet protection
Wear chemical protective gloves, e.g. PVC.
Wear safety footwear or safety gumboots, e.g. Rubber
NOTE:
The material may produce skin sensitisation in predisposed individuals. Care must be taken, when removing gloves and other protective
equipment, to avoid all possible skin contact.
Body protection
See Other protection below
Other protection
Overalls.
P.V.C apron.
Respiratory protection
Particulate. (AS/NZS 1716 & 1715, EN 143:2000 & 149:001, ANSI Z88 or national equivalent)
SECTION 9 Physical and chemical properties
Information on basic physical and chemical properties
Appearance
Clear Liquid
Physical state
Free-flowing Paste
Relative density (Water = 1)
1.10-1.20
Odour
Not Available
Partition coefficient n-octanol
/ water
Not Available
Odour threshold
Not Available
Auto-ignition temperature (°C)
Not Available
pH (as supplied)
Not Available
Decomposition
temperature (°C)
Not Available
Melting point / freezing point
(°C)
Not Available
Viscosity (cSt)
Not Available
Initial boiling point and boiling
range (°C)
Not Available
Molecular weight (g/mol)
Not Available
Flash point (°C)
Not Available
Taste
Not Available
Evaporation rate
Not Available
Explosive properties
Not Available
Flammability
Not Available
Oxidising properties
Not Available
Upper Explosive Limit (%)
Not Available
Surface Tension (dyn/cm or
mN/m)
Not Available
Lower Explosive Limit (%)
Not Available
Volatile Component (%vol)
Not Available
Vapour pressure (kPa)
Not Available
Gas group
Not Available
Solubility in water
Immiscible
pH as a solution (Not
Available%)
Not Available
Vapour density (Air = 1)
Not Available
VOC g/L
Not Available
SECTION 10 Stability and reactivity
Version No:
1.1
Page
4
of
8
ClearWeld Part A, Resin
Issue Date:
10/07/2022
Print Date:
10/07/2022
Continued...