SDS

Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014
_____________________________________________________________________________________________
_____________________________________________________________________________________________
Page 6 / 11
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to
missing tests no recommendation to the glove material can be given for the product/ the preparation/ the
chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
· Material of gloves
Butyl rubber, BR
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and
varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of
the glove material cannot be calculated in advance and has therefore to be checked prior to the application.
· Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
· Eye protection:
Safety glasses
Goggles recommended during refilling
9. PHYSICAL AND CHEMICAL PROPERTIES
· 9.1 Information on basic physical and chemical properties ·
General Information
· Appearance:
Form: Liquid
Colour: Light yellow
· Odour: Characteristic
· Odour threshold: Not determined.
· pH-value: Not determined.
· Change in condition
Melting point/Melting range: Undetermined.
Boiling point/Boiling range: > 200°C (> 392 °F)
· Flash point: > 93,3°C (> 200 °F)
· Flammability (solid, gaseous): Not applicable.
· Ignition temperature:
Decomposition temperature: Not determined.
· Self-igniting: Product is not selfigniting.
· Danger of explosion: Product does not present an explosion hazard.
· Explosion limits:
Lower: Not determined.
Upper: Not determined.