SAFETY DATA SHEET Issuing Date 27-Oct 2014 Revision Date 17-Oct-2014 Revision Number 1 1.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ Skin corrosion/irritation Category 1B Serious eye damage/eye irritation Category 1 Skin sensitization Category 1 GHS Label elements, including precautionary statements Emergency Overview Signal word Warning Hazard Statements Causes severe skin irritation May cause serious eye damage / eye irritation May cause an allergic skin re
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ Ingestion IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell Rinse mouth Do NOT induce vomiting Precautionary Statements - Storage Store locked up Precautionary Statements - Disposal Dispose of contents/container to an approved waste disposal plant Hazards not otherwise classified (HNOC) Not applicable Unknown Tox
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ Inhalation Remove to fresh air. Get medical attention immediately if symptoms occur. If breathing is difficult, (trained personnel should) give oxygen. If breathing has stopped, give artificial respiration. Get medical attention immediately. Avoid direct contact with skin. Use barrier to give mouth-to-mouth resuscitation.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Personal Precautions Attention! Corrosive material. Avoid contact with skin, eyes or clothing. Ensure adequate ventilation. Use personal protective equipment as required. Evacuate personnel to safe areas.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ Eyewash stations Ventilation systems Individual protection measures, such as personal protective equipment Eye/Face Protection Tight sealing safety goggles. Face protection shield. Skin and Body Protection Wear protective gloves and protective clothing. Long sleeved clothing. Chemical resistant apron. Impervious gloves.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 10. STABILITY AND REACTIVITY Reactivity No data available. Chemical stability Stable under recommended storage conditions. Possibility of Hazardous Reactions None under normal processing. Hazardous Polymerization Hazardous polymerization does not occur. Conditions to avoid Exposure to air or moisture over prolonged periods.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 2,4,6Tri(dimethylaminomethyl)phen ol 90-72-2 = 1000 mg/kg ( Rat ) = 1280 mg/kg ( Rat ) - 1-(2-Aminoethyl) piperazine 140-31-8 = 2140 mg/kg ( Rat ) = 880 µL/kg ( Rabbit ) - Benzyl alcohol 10051-6 = 1230 mg/kg ( Rat ) = 2 g/kg ( Rabbit ) = 8.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 12. ECOLOGICAL INFORMATION Ecotoxicity Harmful to aquatic life with long lasting effects.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ California Hazardous Waste Codes 331 Chemical Name California Hazardous Waste Ethylbenzene 100-41-4 Toxic Ignitable 14.
84785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ CWA (Clean Water Act) This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR 122.21 and 40 CFR 122.
1184785 - Plastic Epoxy Hardener - Syringe - Part B Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 16.
SAFETY DATA SHEET Issuing Date 28-Oct 2014 Revision Date 17-Oct-2014 Revision Number 1 1.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 2. HAZARDS IDENTIFICATION Classification This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ Inhalation IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing Call a POISON CENTER or doctor/physician if you feel unwell Ingestion IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell Rinse mouth Do NOT induce vomiting Precautionary Statements - Storage Store locked up Precautionary St
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ · After swallowing: Rinse out mouth and then drink plenty of water. Do not induce vomiting; call for medical help immediately. · 4.2 Most important symptoms and effects, both acute and delayed Allergic reactions Nausea Dizziness · Hazards Danger of impaired breathing. · 4.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ 7. HANDLING AND STORAGE · 7.1 Precautions for safe handling Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. · Information about fire - and explosion protection: No special measures required. · 7.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ · Vapour pressure: Not determined. · Density at 20°C: · Relative density Vapour density · Evaporation rate 1,13 g/cm³ Not determined. · Not determined. Not determined. · Solubility in/Miscibility with water: Not miscible or difficult to mix. · Partition coefficient (n-octanol/water): Not determined.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ · Additional toxicological information: The product shows the following dangers according to the calculation method of the General EU Classification Guidelines for Preparations as issued in the latest version: Irritant 12. ECOLOGICAL INFORMATION · 12.1 Toxicity · Aquatic toxicity: The product contains materials that are harmful to the environment.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ · IMDG, IATA · Class Not Regulated · 14.4 Packing group · DOT, ADR, IMDG, IATA Not Regulated · 14.5 Environmental hazards: · Marine pollutant: Not Regulated · Special marking (IATA): Not applicable. · 14.6 Special precautions for user Not applicable. · 14.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ · IARC (International Agency for Research on Cancer) None of the ingredients is listed. · TLV (Threshold Limit Value established by ACGIH) None of the ingredients is listed. · NIOSH-Ca (National Institute for Occupational Safety and Health) None of the ingredients is listed.
Clear Epoxy Resin – Syringe – Part A Revision Date 17-Oct-2014 _____________________________________________________________________________________________ Disclaimer The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication.