SDS

Safety Data Sheet
According to OSHA Hazard Communication Standard, 29 CFR 1910.1200
Initial preparation date: 02.11.2019
Revision date: 06.07.2023
Page 5 of 11
Generated using Total SDS™ (patent-pending), www.totalsds.com
If engineering controls do not maintain airborne concentrations below recommended exposure limits
(where applicable) or to an acceptable level (in countries where exposure limits have not been
established), an approved respirator must be worn.
General hygienic measures:
Avoid contact with skin, eyes and clothing.
Wash hands before breaks and at the end of work.
Wash contaminated clothing before reuse.
Information on basic physical and chemical properties
Appearance Liquid
Odor Not determined or not available.
Odor threshold Not determined or not available.
pH Not determined or not available.
Melting point/freezing point Not determined or not available.
Initial boiling point/range Not determined or not available.
Flash point (closed cup) >200°C
Evaporation rate Not determined or not available.
Flammability (solid, gas) Not determined or not available.
Upper flammability/explosive limit Not determined or not available.
Lower flammability/explosive limit Not determined or not available.
Vapor pressure Not determined or not available.
Vapor density Not determined or not available.
Density Not determined or not available.
Relative density Not determined or not available.
Solubilities Not determined or not available.
Partition coefficient (n-octanol/water) Not determined or not available.
Auto/Self-ignition temperature Not determined or not available.
Decomposition temperature Not determined or not available.
Dynamic viscosity 16,000 - 30,000 cps (25°C)
Kinematic viscosity Not determined or not available.
Explosive properties Not determined or not available.
Oxidizing properties Not determined or not available.
Other information
Reactivity:
No decomposition if stored and applied as directed.
Chemical stability:
Stable under recommended storage conditions.
Possibility of hazardous reactions:
Product will not undergo hazardous polymerization.
Conditions to avoid:
SECTION 9: Physical and chemical properties
SECTION 10: Stability and reactivity