SDS

Ingredient
TEEL-1
TEEL-2
TEEL-3
piperazine
0.09 ppm
8.9 ppm
54 ppm
silica amorphous
18 mg/m3
200 mg/m3
1,200 mg/m3
silica amorphous
18 mg/m3
100 mg/m3
630 mg/m3
silica amorphous
120 mg/m3
1,300 mg/m3
7,900 mg/m3
silica amorphous
45 mg/m3
500 mg/m3
3,000 mg/m3
silica amorphous
18 mg/m3
740 mg/m3
4,500 mg/m3
Ingredient
Original IDLH
Revised IDLH
Talc
1,000 mg/m3
Not Available
piperazine
Not Available
Not Available
silica amorphous
3,000 mg/m3
Not Available
Exposure controls
Appropriate engineering
controls
Engineering controls are used to remove a hazard or place a barrier between the worker and the hazard. Well-designed engineering controls can
be highly effective in protecting workers and will typically be independent of worker interactions to provide this high level of protection.
The basic types of engineering controls are:
Process controls which involve changing the way a job activity or process is done to reduce the risk.
Individual protection
measures, such as personal
protective equipment
Eye and face protection
Safety glasses with side shields.
Chemical goggles. [AS/NZS 1337.1, EN166 or national equivalent]
Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants.
Skin protection
See Hand protection below
Hands/feet protection
Wear chemical protective gloves, e.g. PVC.
Wear safety footwear or safety gumboots, e.g. Rubber
Body protection
See Other protection below
Other protection
Overalls.
P.V.C apron.
Barrier cream.
Respiratory protection
Type -P Filter of sufficient capacity. (AS/NZS 1716 & 1715, EN 143:2000 & 149:2001, ANSI Z88 or national equivalent)
SECTION 9 Physical and chemical properties
Information on basic physical and chemical properties
Appearance
Tan Paste
Physical state
Free-flowing Paste
Relative density (Water = 1)
Not Available
Odor
Not Available
Partition coefficient n-octanol
/ water
Not Available
Odour threshold
Not Available
Auto-ignition temperature (°C)
Not Available
pH (as supplied)
Not Available
Decomposition
temperature (°C)
Not Available
Melting point / freezing point
(°C)
Not Available
Viscosity (cSt)
Not Available
Initial boiling point and boiling
range (°C)
Not Available
Molecular weight (g/mol)
Not Available
Flash point (°C)
Not Available
Not Available
Evaporation rate
Not Available
Explosive properties
Not Available
Flammability
Not Available
Oxidising properties
Not Available
Upper Explosive Limit (%)
Not Available
Surface Tension (dyn/cm or
mN/m)
Not Available
Lower Explosive Limit (%)
Not Available
Volatile Component (%vol)
Not Available
Vapour pressure (kPa)
Not Available
Gas group
Not Available
Solubility in water
Immiscible
pH as a solution (1%)
Not Available
Vapour density (Air = 1)
Not Available
VOC g/L
Not Available
SECTION 10 Stability and reactivity
Reactivity
See section 7
Chemical stability
Product is considered stable and hazardous polymerisation will not occur.
Version No:
7.14
Page
6
of
10
PlasticBonder™ Syringe Tan - Part B
Issue Date:
10/25/2023
Print Date:
02/07/2024
Continued...