SDS

ManualsBrandsJ-B Weld ManualsEpoxy & AccessoriesJ-B KwikWeld 2 oz. Fast Set Epoxy (Case of 6)

SAFETY DATA SHEET

Issuing Date 11-Nov- 2014 Revision Date 11-Nov-2014 Revision Number 1

1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE

COMPANY/UNDERTAKING

Product identifier

Product SDS Name Steel Reinforced Epoxy Resin – Twin Tubes - Part A

J-B Weld FG SKU Part Numbers Covered

8265, 8265F, 8276, 8276F, 8265S, 8265A, 8265H, 8272, 8272F, 8280, 8280F, 8281, 80165, 7265S, 7280,

8276A, 8273H, 8270, 8270F, 8271, 80176, 7276, 7270

J-B Weld Product Names Covered

J-B Weld™ (all Twin Tubes), KwikWeld™ (all Twin Tubes), MarineWeld™ (Twin Tubes Only)

J-B Weld Product Type

Steel Reinforced Epoxy

Recommended use of the chemical and restrictions on use

Recommended Use General Purpose Adhesive

Uses advised against No information available

Details of the supplier of the safety data sheet

Supplier Name

J-B WELD COMPANY,LLC

Supplier Address

1130 COMO ST

SULPHUR SPRINGS, TX 75482

USA

Emergency Telephone Numbers

Transportation Emergencies: Chemtrec (24 hour transportation emergency response info):

800-424-9300 or 703-527-3887

Poison/Medical Emergencies: Poison Control Centers (24 hour emergency poison / medical

response info): 800-222-1222

Supplier Email

Supplier Phone Number

info@jbweld.com

903-885-7696

2. HAZARDS IDENTIFICATION

OSHA/HCS status

This material is considered hazardous by the OSHA Hazard Communication Standard

(29 CFR 1910.1200).

Classification of the

substance or mixture

GHS label elements

SKIN CORROSION/IRRITATION - Category 2

SERIOUS EYE DAMAGE/ EYE IRRITATION - Category 2B

SKIN SENSITIZATION - Category 1

Hazard pictograms

Signal word

Warning!

Hazard statements

Causes skin and eye irritation.

May cause an allergic skin reaction.

Summary of content (22 pages)

PAGE 1
SAFETY DATA SHEET Issuing Date 11-Nov- 2014 Revision Date 11-Nov-2014 Revision Number 1 1.
PAGE 2
Precautionary statements Prevention Response Storage Disposal Hazards not otherwise classified Wear protective gloves. Wear eye or face protection. Avoid breathing dust. Wash hands thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace. IF ON SKIN: Wash with plenty of soap and water. Take off contaminated clothing. Wash contaminated clothing before reuse. If skin irritation or rash occurs: Get medical attention.
PAGE 3
Over-exposure signs/symptoms Inhalation No specific data. Skin contact Adverse symptoms may include the following: irritation redness Adverse symptoms may include the following: pain or irritation watering redness No specific data. Eye contact Ingestion Indication of immediate medical attention and special treatment needed, if necessary Notes to physician Treat symptomatically. Contact poison treatment specialist immediately if large quantities have been ingested or inhaled.
PAGE 4
6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Provide adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Put on appropriate personal protective equipment.
PAGE 5
8. EXPOSURE CONTROLS/PERSONAL PROTECTION Control parameters Occupational exposure limits Ingredient name CAS # Exposure limits crystalline silica non-respirable 14808-60-7 OSHA PEL Z3 (United States, 9/2005). Notes: 250/(%SiO2+5) TWA: 250 MPPCF / (%SiO2+5) 8 hours. Form: Respirable OSHA PEL Z3 (United States, 9/2005). Notes: 10/(SiO2+2) TWA: 10 MG/M3 / (%SiO2+2) 8 hours. Form: Respirable ACGIH TLV (United States, 3/2012). TWA: 0.025 mg/m³ 8 hours.
PAGE 6
Other skin protection Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases, or dusts.
PAGE 7
11.
PAGE 8
Eye contact Adverse symptoms may include the following: pain or irritation watering redness No specific data. Adverse symptoms may include the following: irritation redness No specific data. Inhalation Skin contact Ingestion Delayed and immediate effects and also chronic effects from short and long term exposure Short term exposure Potential immediate effects Not available. Potential delayed effects Not available. Long term exposure Potential immediate effects Not available.
PAGE 9
Disposal methods The generation of waste should be avoided or minimized wherever possible. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor.
PAGE 10
SARA 311/312 Classification Immediate (acute) health hazard Composition / information on ingredients Name % Fire hazard Sudden release of pressure Reactive Immediate (acute) health hazard Delayed (chronic) health hazard reaction product: bisphenol-A(epichlorhydrin); epoxy resin 10-30 No. No. No. Yes. No. crystalline silica non-respirable 0.1-1 No. No. No. No. Yes carbon black respirable 0.1-1 No. No. No. No. Yes.
PAGE 11
BCF = Bioconcentration Factor GHS = Globally Harmonized System of Classification and Labelling of Chemicals IATA = International Air Transport Association IBC = Intermediate Bulk Container IMDG = International Maritime Dangerous Goods LogPow = logarithm of the octanol/water partition coefficient MARPOL 73/78 = International Convention for the Prevention of Pollution From Ships, 1973 as modified by the Protocol of 1978.
PAGE 12
SAFETY DATA SHEET Issuing Date 11-Nov- 2014 Revision Date 11-Nov-2014 Revision Number 1 1.
PAGE 13
Precautionary statements Prevention Wear protective gloves, Wear protective clothing. Do not eat, drink or smoke when using this product. Wash hands thoroughly after handling. Response IF SWALLOWED: Call a POISON CENTER or physician if you feel unwell. Rinse mouth. IF ON SKIN: Wash with plenty of soap and water. Call a POISON CENTER or physician if you feel unwell. Wash contaminated clothing before reuse. Storage Disposal Not applicable.
PAGE 14
Over-exposure signs/symptoms Inhalation No specific data. Skin contact No specific data. Eye contact No specific data. Ingestion No specific data. Indication of immediate medical attention and special treatment needed, if necessary Notes to physician In case of inhalation of decomposition products in a fire, symptoms may be delayed. The exposed person may need to be kept under medical surveillance for 48 hours. Specific treatments No specific treatment.
PAGE 15
6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures For non-emergency personnel For emergency responders Environmental precautions No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Provide adequate ventilation. Wear appropriate respirator when ventilation is inadequate.
PAGE 16
7. HANDLING AND STORAGE Conditions for safe storage, including any incompatibilities Do not store below the following temperature: 35°C (95°F). Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see Section 10) and food and drink. Keep container tightly closed and sealed until ready for use.
PAGE 17
Skin protection Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Considering the parameters specified by the glove manufacturer, check during use that the gloves are still retaining their protective properties. It should be noted that the time to breakthrough for any glove material may be different for different glove manufacturers.
PAGE 18
Conditions to avoid No specific data Incompatible materials No specific data Hazardous decomposition products Under normal conditions of storage and use, hazardous decomposition products should not be produced. 11.
PAGE 19
Eye contact No known significant effects or critical hazards. Inhalation Skin contact Exposure to decomposition products may cause a health hazard. Serious effects may be delayed following exposure. Harmful in contact with skin. Ingestion Harmful if swallowed. Symptoms related to the physical, chemical and toxicological characteristics Eye contact No specific data. Inhalation No specific data. Skin contact No specific data. Ingestion No specific data.
PAGE 20
Product/ingredient name LogPow BCF Potential 2,4,6-tris 9dimethylaminomethyl) phenol 0.219 - low titanium dioxide - 352 low Mobility in soil Soil/water partition coefficient (KOC) Other adverse effects Not available. No known significant effects or critical hazards. 13. DISPOSAL CONSIDERATIONS Disposal methods The generation of waste should be avoided or minimized wherever possible.
PAGE 21
15. REGULATORY INFORMATION U.S. Federal regulations TSCA 8(a) PAIR: Siloxanes and Silicones, di-Me, reaction products with silica TSCA 9(a) CDR Exempt/partial exemption: Not determined United States Inventory (TSCA 8b): All components are listed or exempted.
PAGE 22
Japan inventory: All components are listed or exempted. Korea inventory: All components are listed or exempted. Malaysia Inventory (EHS Register): Not determined. New Zealand Inventory of Chemicals (NZloC): All components are listed or exempted. Phillipines inventory (PICCS): All components are listed or exempted. Taiwan inventory (CSNN): Not determined. Substances of very high concern None of the components are listed. 16.