SDS

Safety Data Sheet
According to OSHA Hazard Communication Standard, 29 CFR 1910.1200
Initial preparation date: 03.06.2019 Page 4 of 9
HighHeat Stick
Generated using Total SDS™ (patent-pending), www.GSMSDS.com
Country (Legal Basis) Substance Identifier Permissible concentration
United States (OSHA) Silica, crystalline quartz 14808-60-7 OSHA Z-3 TWA 0.1 mg/m³
(Respirable fraction); 0.3 mg/m³
(Total dust)
Cristobalite 14464-46-1 TWA: 0.05 mg/m³
ACGIH Silica, crystalline quartz 14808-60-7 ACGIH TLV TWA 0.025 mg/m³
(Respirable fraction)
Cristobalite 14464-46-1 8-Hour Exposure Limit (TLV-TWA):
0.025 mg/m³
NIOSH Silica, crystalline quartz 14808-60-7 NIOSH TWA 0.05 mg/m³
Cristobalite 14464-46-1 REL: 0.05 mg/m³
Cristobalite 14464-46-1 Immediately dangerous to life or
health (IDLH) concentration: 25
mg/m³
Biological limit values:
No biological exposure limits noted for the ingredient(s).
Information on monitoring procedures:
Monitoring of the concentration of substances in the breathing zone of workers or in the general workplace
may be required to confirm compliance with an OEL and adequacy of exposure controls.
Biological monitoring may also be appropriate for some substances.
Appropriate engineering controls:
Emergency eye wash fountains and safety showers should be available in the immediate vicinity of use or
handling.
Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapor and
mists below the applicable workplace exposure limits (Occupational Exposure Limits-OELs) indicated above.
Personal protection equipment
Eye and face protection:
Safety goggles or glasses, or appropriate eye protection.
Skin and body protection:
Select glove material impermeable and resistant to the substance.
Wear appropriate clothing to prevent any possibility of skin contact.
Respiratory protection:
If engineering controls do not maintain airborne concentrations below recommended exposure limits
(where applicable) or to an acceptable level (in countries where exposure limits have not been
established), an approved respirator must be worn.
General hygienic measures:
Avoid contact with skin, eyes and clothing.
Wash hands before breaks and at the end of work.
Wash contaminated clothing before reuse.
SECTION 9: Physical and chemical properties
Information on basic physical and chemical properties
Appearance Metallic, grey-beige solid.
Odor Ethereal
Odor threshold Not determined or not available.
pH Not determined or not available.
Melting point/freezing point Not determined or not available.