Instructions / Assembly
7
12)
Set the next cabinet tight to the rst
cabinet and use clamps to hold it place
while you level it and make sure that
the front edges are ush. Attach the two
cabinets together using 1 1/8" particle
board screws. Attach the cabinet to the
wall with 2 1/2" screws into the studs.
Continue with the same process for all
base cabinets.
3.2 FILLERS
A ller is always required against a wall. To cut your ller, measure from the cabinet to the wall
and cut the ller accordingly.
Hold the ller in place; turn it over and on the back side make a pencil mark at the top and
bottom where it should be cut. To prevent chipping when cutting llers, place masking tape over
the surface that is being cut. Join the two marks with a pencil line and saw along that line. Put
the ller in place and drill a pilot hole at hinge-level through the cabinet and into the ller. Attach
the ller to the adjacent cabinet by fastening together with wood screws.
Filler
11) For designs without a corner cabinet,
start with the rst cabinet leaving space
for a ller, as per your plan.