User's Manual

BLUEBEE - Wireless Internet Sharing Wizard
- 26 -
card in the same manner and enable BT Network Adapter.
6.5. ‘Select User Mode’ window prompt while running PAN
If ‘Select User Mode’ window prompts while running PAN, it might be the case where the system
cannot recognize the USB adapter. Please verify if the USB adapter is properly plugged in.
If you are still encountering the same message, check ‘Device Manager’ from ‘My Computer’ and
see if USB is properly installed. And if not, unplug the USB adapter from the USB port and plug in
again so that system can install the USB adapter automatically.
6.6. PAN Troubleshooting
After you have established connection to BlueNetwork, if you cannot use the Internet, then open
MS-DOS prompt and type ‘ping www.yahoo.com’. If the result is ‘destination is unreachable’ or
‘Hardware error’, then reboot your computer and run PAN again.
6.7. Joining BlueNetwork Troubleshooting
When you join the BlueNetwork, you will see a message like [Figure 6-1] and then it will display ‘IP
address acquired’ message as in [Figure 3-3].
If you only see a message like [Figure 6-1], without ‘IP address acquired’ message, then it means
IP address was not successfully acquired. In this case, exit PAN and run PAN again, and then try to
join again.
Figure 6-1: Device Connecting Message