User's Manual

3. To operate the GPS/MAP application software
To open and use the GPS/MAP application, in your PDA :
 make sure your BGP-2000 is connected with the host via Bluetooth
 Open the GPS/MAP application on the host
 Enter into the GPS/MAP application operation
You can easily use all the function of GPS/MAP application software by following the
details operation guidance described in the user guide of the GPS/MAP application
software.
4. To charge the battery of the BGP-2000
Before use BGP-2000, the Lithium-polymer battery inside the BT GPS must be fully
charged by plugging the charger’s plug into the power jack. When the Battery is fully
charged, the battery indicator will be changed to green light. Approximately 3 hours are
required to fully charge the batteries.
Caution : Do not use other charger to charge the BT GPS.
Troubleshooting
The solutions to some common problems
1. Sometimes, it took everything is alright, but you can not connect to BGP-2000.
You should try to delete the old BGP-2000 icon on your Bluetooth manager
software, and re-charging again.
2. Open and close your application on the standard procedures, it will make your
Bluetooth connection is normal and functional. Otherwise, sometimes you have to
reset your PDA and Bluetooth GPS receiver to bring them back.