Owner manual

ManualsBrandsJ.P. Instruments ManualsEquipmentEDM 700/800/711 Pilots Guide

For Your Safe Flight Page 27

Refer to the flow chart. Then tap the STEP button to complete the entry

and advance to the Manual mode.

Adding Fuel and Auxiliary Tanks

If you either

a) added less than full fuel to only

the main tanks, or

b) topped the main tanks but have

some fuel remaining in the

auxiliary tanks,

then select FILL + and the next display

will ask you how much you added: .0 GAL

(or selected units). Hold the LF button to

count up, tap the LF button to count

down. The count up will stop at full

tanks, since you cannot add more fuel

than would top the tanks.

If you added fuel to only the main tanks,

then input how much you added.

If you topped the main tanks, but have

some fuel remaining in the auxiliary

tanks, input how much is now in the

auxiliary tanks.

You can “add” a negative amount of fuel

if you remove fuel from the aircraft or

wish to correct the total quantity of fuel on board.

Accumulate Total—Trip Total

You may either display total fuel used since the last time you informed

the EDM that the aircraft was refueled, or for an extended trip with

multiple fuel stops. This selection affects only the USD parameter. How

to select whether to accumulate or reset is described in “Pilot

Programming” beginning on page 33.

Resetting “USED”

Every time you inform the EDM that the aircraft is refueled, the amount

of fuel used is set to zero, unless the instrument is programmed to

accumulate. The display of fuel used pertains only to the fuel used since

the last time you informed the EDM that the aircraft was refueled.

Power up

FUEL ?N

Pgm Refuel

Program

FILL ?N

FILL ?75 *

Yes Change

Fill ?+

OK Start

Exit Fill

.0 GAL

Done +/-

FILL ?120 *

Yes Add

STEP LF