Owner manual

Page 54 Engine Data Management
missing segment, 6
OIL, 10, 29
Oil temperature, 10, 29
OPEN PRB, 11
Operation
fuel flow option, 26
temperature scanner, 4
Option connector, 47
Outside air temperature. See OAT
P
Panel
Alarm Display, 40
Parameter indexing, 9, 28
Peak EGT, 13
PEAK EGT, 13, 15
Percentage view, 5
Pilot programming, 33
alarm limits, 41
data recording, 39
fuel flow option, 37
Pin assignments, option connector, 47
Power, best, 3
PPH, 29
Pre-ignition, 23, 25
Pre-leaning. See Leaning, pre-leaning
Primary
Alarm Display, 40
Priority, alarm, 25
Product support, 48
Programming, 33
alarm limits, 41
data recording, 39
fuel flow option, 37
R
Range, normal temperature, 21
Rate
baud, 46
fuel flow, 28, 29
indexing, 37
shock cooling, 19
Real-time, 43
Record, on, off, 43
Recording. See Long Term Memory
Option
RECRD?, 43
Red line, 21
Reference reading, 48
REM, 29
Removing fuel, 27
REQ, 29
RES, 29
Reset
alarm limits, 41
alarms, 25
fuel used, 28
Resolution, EGT display, 34
Rich of Peak, 12
Rough engine, 22
RS-232, 46
Run-up, 18
S
Scanning. See Indexing
Segment
flashing, 6
Select switch, 26
Self-test, 11, See also Diagnostic
Setting the K factor. See Fuel Flow
Setup, 33
alarm limits, 41
fuel flow option, 37
Long Term Memory Option, 39
Shadin Miniflow, 45
Shock cooling, 10, 12, 19, 21
SNAP, 30
Spark plug
fouling, 5, 18, 22
Startup
diagnostics, 11
fuel, 26
STEP button, 8
Stuck valve, 22
Switch, select, 26
T
Tabs, tank, 43
Take-off, 18
Tank capacity
entering at power up, 45
Tanks, fuel
capacity, 26, 43
tabs, 26, 43
Tapping a button, 8
Technical support, 48
Test, self, 11
Time to empty, 29