Installation Manual

FAA APPROVED INSTALLATION MANUAL FOR THE EGT-701 Report 103
INSTALLING THE EGT-701 SCANNER® 1/20/09 Rev-E Page 6 of 30
Continental Engines Oil probe location
Std oil IO-360
A
lt location IO-520/550
IO-360
Alt location
O-470
Requires ¼ NPT to 1/8 NPT reducer Oil reports after thermostat opens
IO-520/550
The oil probe P/N 400505-C is installed by removing the 3/8 or 1/8 pipe plug located on the front of the engine inline
with the push rods. This oil galley feeds the valve lifters. Insert the JPI 1/8 NPT probe supplied with the kit. Check for
leaks after installation. Due to cowling restrictions the alternate oil location may be chosen. The probe leads are
routed back to the cockpit along with the EGT wires. Do not install the Oil Probe in the rear of the engine near the
vernatherm (oil temperature regulator).
Alternate Oil
Location
IO-520/550