How-To Guide

FIBER OPTIC WIRELESS SPEAKER LAMP
Instruction
How to Play:
1. Press the switch“-” at the bottom of the product then the LED glitter lamp will be turned on and you will
hear a “do-do-do-do” prompt tone which means the bluetooth is ready.
2.Turn on the bluetooth settings of your mobile and search and link in bluetooth JR-006. It has been connected
successfully once you hear the prompt tone of “di-do”.
3.Press the switch“0” at the bottom of the product then the LED glitter lamp and blue tooth will be turned off.
4.Please recharge the battery with the USB cable when you hear the low battery warning. The audio effect and
lamp will be weaker if the battery is low.
Bluetooth name: JR-006
Bluetooth version: 5.0
Frequency band: 2402MHz to 2480MHz
Transmission distance: 10 M
Loud speaker : 4
3W sizeΦ45mm
Battery: 3.7v 18650 1200mAh
Charging time :2~3hours, Working time :5~6hours
Charging indicator
：
Green light=full power,Red light=low power
Low Battery Warning
：
prompt tone “do-do-do”
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not expressly approved by the
party responsible for compliance. such modifications could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
This equipment complies with FCC's RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna(s) must not be co-located or conjunction with any other antenna or
transmitter.