User's Manual

ManualsBrandsJ-Three International Holding ManualsAudio EquipmentBluetooth Headset

J-3 International Holding Co.,LTD Electronic Division

Bluetooth Headset User Guide

Operation:

◎ Turning on the headset

Switch on the headset by pressing “Function key” max. 3 seconds and a beep tone with LED flashing indicates

the headset is on.

◎ Putting HS in Pairing Mode

Press and hold the “Function key” for 6 seconds, blinking of red and green LEDs alternately indicates the

headset is in Pairing Mode.

＊The default Passkey required for pairing is 0000. If the headset is not successfully paired within the

Pairing Timeout (120 seconds) period, it shuts off automatically.

⊕Your headset needs to pair with Bluetooth Phone before you use, please refer to your phone

manual for user instruction.

◎ Answer incoming calls

Volume Adjust

Charging

Status LED

MIC

Function key

Status

LED

Summary of content (4 pages)

PAGE 1
J-3 International Holding Co.,LTD Electronic Division Bluetooth Headset User Guide Volume Adjust Charging Status LED Function key Status LED MIC Operation: ◎ Turning on the headset Switch on the headset by pressing “Function key” max. 3 seconds and a beep tone with LED flashing indicates the headset is on. ◎ Putting HS in Pairing Mode Press and hold the “Function key” for 6 seconds, blinking of red and green LEDs alternately indicates the headset is in Pairing Mode.
PAGE 2
J-3 International Holding Co.,LTD Electronic Division Pressing the “Function key” to answer the call when there is an incoming call present. The green LED will continue to flash fast while the call is in session. ◎ Transferring calls Calls can be transferred from phone to the headset OR from the headset to phone. Note: It varies from phone to phone; please refer to your mobile phone user’s manual.
PAGE 3
J-3 International Holding Co.,LTD Electronic Division FCC Safety Statements The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. The radiated output power is far below the FCC radio frequency exposure limits.
PAGE 4
J-3 International Holding Co.,LTD Electronic Division conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.