User's Manual

3
◎
Disconnecting calls
While a call is in session on the headset, press the “Function key” to disconnect the call. After the call is
disconnected, the green LED will flash normally.
◎
Putting HS in Standby Mode
The headset can be put into Standby Mode in different ways:
l Turning on the headset but not going into Pairing Mode
l After successfully pairing the headset
l Disconnecting from a call
Note: The headset can receive incoming calls in Standby Mode.
◎
Locally changing the volume on HS
Press the Right button upward to increase the listening volume on the headset.
Press the Left button downward to decrease the listening volume on the headset.
◎
Remotely changing the volume on HS
The headset listening volume can be remotely changed by the blue tooth mobile phone. Please refer to you
blue tooth mobile phone manual for volume adjusting.
◎
Low-battery indication
The headset LED will flash red instead of green and a short beep every 30 seconds when the battery is low.
◎
Battery recharging
Allow approximately 1 hours to fully recharge an empty battery.
Li-ion Charger LED indicators:
◎ Green: ready for charging/battery is full.
◎ Red: charging in progress
◎
Turning off the headset
Switch off the power by pressing the “Function key” max. 3 seconds, a beep tone and LED off indicate the
headset is off.
Recommend bluetooth phone
Nokia 6310, Nokia 6310i, Nokia 8910,
Ericsson T39, Sony Ericsson T68, Sony Ericsson T68i,
Recommend Non-Bluetooth cellular Phone( with our Bluetooth Phone Adaptor)
Cable-M01: Motorola 3688, Motorola 8088, MotorolaV66, Motorola T289, Motorola T720,
Motorola 7689, Motorola L2000, Panasonic GD85, NEC 250I, OKWAP 166
Cable-N01: Nokia 3310, Nokia 8210, Nokia 8310, Nokia 8850, Palmax XG5D