User's Manual

Minix780G Series User's Manual

- 10 -

2.3.2 Installation of the CPU Cooler

For proper installation, please kindly refer to the instruction manuals of your CPU Cooler.

2.4 Installation of Memory Modules

This mainboard provides two 200-pin DDRII (Double Data Rate) SODIMM slots and supports

'XDO&KDQQHO0HPRU\7HFKQRORJ\)RUGXDOFKDQQHOFRQ¿JXUDWLRQ\RXDOZD\VQHHGWRLQVWDOOWZR

identical (the same brand, speed, size and chip-type) memory modules in the DDRII DIMM slots

to activate Dual Channel Memory Technology. Otherwise, it will operate at single channel mode.

To install system memory:

1. Power off the computer and unplug the

AC power cord before installing or

removing memory modules.

2. Locate the DIMM slot on the board.

3. Insert the SODIMM module at a 45 degree

angle.

4. Push the SODIMM module back towards the

board until the clips lock the module in place.

5. To remove the DIMM modules, push the two

ejector tabs on the slot outward simultaneously,

and then pull out the DIMM module.

Static electricity can damage the electronic

components of the computer or optional boards.

Before starting these procedures, ensure that you

are discharged of static electricity by touching a

JURXQGHGPHWDOREMHFWEULHÀ\

We suggest there should be active cooling to the chipset area in order to let the motherboard

IXQFWLRQSURSHUO\FRPSOHWHO\ HQFORVHG V\VWHPHQYLURQPHQWZLWKRXWDGHTXDWHDLU ÀRZ ZLOOUHVXOW

in chipset overheat, which is not recommended.