User's Manual
Minix780G Series User's Manual
- 8 -
Chapter 2 Hardware Setup
2.1 Choosing a Computer Chassis
• Choose a chassis big enough to install this mainboard.
• As some features for this mainboard are implemented by cabling connectors on the mainboard
to indicators and switches or buttons on the chassis, make sure your chassis supports all the
features required.
,IWKHUHLVSRVVLELOLW\RIDGRSWLQJVRPHPRUHKDUGGULYHVPDNHVXUH\RXUFKDVVLVKDVVXI¿FLHQW
power and space for them.
• Most chassis have alternatives for I/O shield located at the rear panel. Make sure the I/O shield
RIWKHFKDVVLVPDWFKHVWKH,2SRUWFRQ¿JXUDWLRQRIWKLVPDLQERDUG<RXFDQ¿QG an I/O shield
VSHFL¿FDOO\GHVLJQHGIRUWKLVPDLQERDUGLQLWVSDFNDJH
2.2 Installing Mainboard
Most computer chassis have a base with many mounting holes to allow the mainboard to be
securely attached, and at the same time, prevent
the system from short circuits. There are two ways
to attach the mainboard to the chassis base:
(1)with studs, or (2) with spacers.
Basically, the best way to attach the board is with
studs. Only if you are unable to do this should you
attach the board with spacers. Line up the holes on
the board with the mounting holes on the chassis.
If the holes line up and there are screw holes, you
can attach the board with studs. If the holes line
up and there are only slots, you can only attach with
spacers. Take the tip of the spacers and insert them into the slots. After doing this to all the slots,
you can slide the board into position aligned with slots. After the board has been positioned,
check to make sure everything is OK before putting the chassis back on.
To install this mainboard:
1. Locate all the screw holes on the mainboard and the chassis base.
2. Place all the studs or spacers needed on the chassis base and have them tightened.
3. Face the mainboard’s I/O ports toward the chassis’s rear panel.
4. Line up all the mainboard’s screw holes with those studs or spacers on the chassis.
5. Install the mainboard with screws and have them tightened.