JVAW62 Wireless Display Transmitter Quick Start Guide Rev 1.0 Product information is subject to change without prior notice.
How to mirror 1 Simply plug into laptop or mobile Plug JVAW62 TX to Type C port on laptop or mobile. Wait a few seconds until the flashing light on JVAW62 TX stops, and it will start mirroring automatically. Please make sure to insall and pair to JVAW62 wireless display receiver if flashing over 20 seconds. 2 Stop and restart mirroring Press the JVAW62 TX button to stop mirroring or restart mirroring.
How to pair JVAW62 TX with receiver 1 Turn on pairing mode for receiver Press the reset button (or insert the pin to press) for 2 seconds on JVAW62 wireless display receiver. Release the button when the screen shows “Release the button to pair with ScreenCast”. Please make sure your receiver has been upgraded to the latest version. Release the button to pair with ScreenCast 2 Press the JVAW62 TX button Plug JVAW62 TX on laptop or mobile to provide power.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.