User's Manual

GCube4.0 User Manual V1.0
4 of 8
Turn on the GCube4.0 by sliding the POWER to ON and BATTERY to ON position as Figure .
Figure 5: GCube4.0 Power LED
2. Wait for 17 seconds for OS to boot up.
3. Once OS is complete boot up, the STATUS orange LED will light up and display will show
“Device Starting..” as shown in Figure 6.
Figure 6: GCube4.0 Status LED and display status
4. Wait for 14 seconds for the acquisition software loading and initialize.
5. Once the software is complete loading, the STATUS LED will turn green and the display will
show “Collecting data” and IP address or else the STATUS LED will turn red if there is any
error occurred with the error message show on display.
Figure 7: GCube4.0 complete loading
6. If the STATUS LED is still RED. Check the error message on the OLED display.