Operation Manual

2120
ENEN
MZZ56200MZZ56200
CAMERA
a) Front & Back of the Camera
1. Camera Antenna – Should not be close to the metallic parts.
2. Night Light Switch – The button itself is used as a night light (press to switch the night light ON or
OFF). Alternatively you can use the button 11 on the receiver to switch the camera light ON or OFF
remotely.
3. Lens/IR LED Cover – Infrared LEDs enable better vision during low or no light.
4. Microphone – Hears all the sounds in the monitored room and transmits them to the wireless receiver.
5. Power (9V DC) – To connect the 9V DC power adaptor to the camera.
NOTE: The camera can also be powered by a rechargeable accumulator (included) or 4 AA batteries.
The batteries would only be used if there is no mains power. When powered from an AC adaptor,
inserted accumulator would be recharged.
6. Pair Button – This button is not used for Tiny monitor..
b) Side of the Camera
7. Volume Setting – To adjust the sound alarm sensitivity. The receiver will beep to alert the user when
the sound is above the preset sound level. Adjust the side wheel to increase or decrease the level.
8. Camera ON/OFF Switch – To switch the camera ON or OFF.
CAMERA INSTALLATION
Before you install the camera, carefully plan where and how it should be positioned, and where you will
route the cable of the power adaptor. It is also needed to check the image quality on the receiver before
the camera is installed permanently. The best is to place the wireless receiver on the most common
place where it will be used.
Installation Warnings
Place the camera to optimize the viewing area – select a location that provides a clear view of the area
you want to monitor, which is free from dust and is not in line-of-sight of a strong light source or direct
sunlight. Avoid installing the camera where there are thick walls or any obstructions between the camera
and the receiver.
Night Vision
The camera has built-in infrared LEDs, which provides the camera with the
ability to view a monitored space in poor light conditions. It is important
to use the provided power adaptor (and not the batteries) with the night
vision feature to prolong the viewing period in poor light conditions, as the
built-in IR LEDs will drain the battery more quickly than in regular daytime
use.