Operation Manual

gt432uk rev00

MICROWAVE MODULE POSITION

CORRECT POSITIONS

ON THE DASHBOARD

INCORRECT POSITIONS

CENTRE CONSOLE

DASHBOARD

GLOVES COMPARTMENT

GT - 432

PINK

MICROWAVE SENSITIVITY ADJUSTMENT

MICROWAVE TRIGGER LED

BROWN

GREEN/BLACK

CONNECT TO THE GREEN/BLACK WIRE

OF GT ALARM (WHERE POSSIBLE) OR TO

THE GREEN/BROWN WIRE AS DIAGRAM

TRANSMITTANT SIDE

FIG. A

COURTESY LIGHT

+12V

ORIGINAL DOOR

PIN SWITCH

DIODE 1N4007

GREEN/BROWN

GT ALARM

GREEN/BLACK

GT432

FIG. B

GT 432 FITTING INSTRUCTIONS

CONNECT TO THE PINK WIRE OF

GT ALARM

BELOW.

PAGE 1
GT 432 FITTING INSTRUCTIONS TRANSMITTANT SIDE MICROWAVE TRIGGER LED MICROWAVE SENSITIVITY ADJUSTMENT GT - 432 BROWN CONNECT TO THE GREEN/BLACK WIRE OF GT ALARM (WHERE POSSIBLE) OR TO THE GREEN/BROWN WIRE AS DIAGRAM BELOW. PINK GREEN/BLACK FIG. A FIG.
PAGE 2
FITTING INSTRUCTIONS CONNECTIONS 1. Isolate the vehicle’s battery prior to starting the installation. 2. Mount the module as stated in the paragraph “MODULE POSITION”. 3. Connect the BROWN wire to a good earth. 4. Connect the PINK wire (positive when armed alarm) to the PINK wire of GT alarm. 5. Connect the GREEN/BLACK wire to the GREEN/BLACK wire of the GT alarm as indicated in FIG.A. MODULE POSITION Position the module in the passenger’s compartment, behind the centre console (radio space).