Operation Manual

JK-06 PROFI TEL KIT 1/4 MGK55107
JK-06 PROFI TEL KIT
• Detailed manuals for all included components can be found on the enclosed CD or on the Jablotron website www.jablotron.com
1. Kit contents
All items in the kit are enrolled and preprogrammed. The
detectors and remote controls have batteries pre-installed.
Item description address
JA-60N wireless door sensor 1
JA-60P wireless motion detector 2
JA-60F wireless keypad c1
RC-44 remote control c2
UC-260 wireless indoor siren panel is enrolled
The RC-42 is the same remote control as the RC-44 except that it is built
into the housing witch only two buttons (
& ), which have identical
functions to the left pair of RC-44 buttons.
2. Before installation
Decide upon suitable locations for all of the items. The wireless
keypad should be within 20m of the control panel.
There should be power and a telephone line available for the
control panel.
3. Control panel installation
a) Install the control panel - see drilling plan on the last page
of this manual.
b) Connect the telephone line and telephone cable to the
connectors on the telephone module inside the control panel
c) Check that the telephone works normally as before
d) Install and connect the backup battery to the control panel
e) Connect the AC power to the control panel
f) The Green LED should flash in the control panel
g) Connect the keypad’s batteries (pull out the red tape to
activate batteries). P will be indicated on the keypad
(programming mode).
• If F is indicated, there is no communication with the control
panel.
• Enter F0 6060 to reopen the P mode in case you accidentally
close it by pushing the N key
• To save the keypad batteries, close its cover while it is in the P
mode
1,3 Ah
Telephone
Tel. line
Recording
button
Microphone
Telephone module
Back up battery
Reset pins
Green LED