User Manual
Table Of Contents
- THANK YOU
- ABOUT YOUR JABRA FREEWAY
- WHAT YOUR SPEAKERPHONE CAN DO
- GETTING STARTED
- CHARGE YOUR SPEAKERPHONE
- TURNING YOUR SPEAKERPHONE ON AND OFF
- PAIRING IT WITH YOUR PHONE/DEVICE
- PAIR A NEW OR SECOND DEVICE
- CONNECTING WITH YOUR PHONE
- PLACE THE SPEAKERPHONE IN YOUR VEHICLE
- HOW TO
- JABRA VOICE FEATURES
- ADDITIONAL FEATURES
- TROUBLESHOOTING & FAQ
- Taking care of your Speakerphone
- Glossary
12
ENGLISH
JABRA FREEWAY
If your radio supports RDS it will automatically adjust to the new
frequency. If it doesn’t you have to manually set the radio to the
new frequency.
Note: When in FM mode the volume controls on the FREEWAY are
disabled. Use the volume control on your car radio instead.
QUICK REFERENCE TABLE FOR MANUALLY CONTROLLING YOUR
JABRA FREEWAY
Function Action
Entering pairing
mode
Press and hold the Answer/end
button while sliding the Power switch
into the On position
Cancel pairing mode Tap the Answer/end button
Answer call Tap the Answer/end button
End a call Tap the Answer/end button
Reject a call Double tap the Answer/end button to
reject an incoming call
Initiate phone voice
dial*
Tap the Voice button when connected
and not on an active call.
Enable or disable
Voice Guidance and
commands
Press and hold the Voice button while
sliding the Power switch into the On
position. You will hear ”Voice on” when
you enable and ”Voice o” when you
disable the voice features.
Reset to factory
default
Turn on the FREEWAY and press and
hold the Answer/end, Voice and Mute
button together for about 6 seconds.
When the FREEWAY is reset it will
automatically go into pairing mode.
Night driving mode When powered on you can tap the
Vol- and Vol+ simultaneously to
disable the LED’s. And again to enable
them again. The LED’s will be enabled
every time you reconnect or power on
the FREEWAY.
* Phone dependent