Instruction manual
5
7. Pairing it with your phone
Headsets are connected to phones using a procedure called ‘pairing’. By
following a few simple steps, a phone can be paired with a headset in a
matter of minutes. ( See g 3)
1. Put the headset in pairing mode
• When you turn on your Jabra BT2010 for the rst time, the headset will
automatically start up on pairing mode – i.e. it is discoverable for your
phone. When the headset is in pairing mode the LED is constantly lit.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT2010
• Follow your phone’s instruction guide. First make sure that Bluetooth is
activated on your mobile phone. Then set your phone to discover the
headset. This usually involves going to a ‘setup,’ ‘connect’ or ‘Bluetooth’
menu on your phone and selecting the option to ‘discover’ or ‘add’ a
Bluetooth device.*
3. Your phone will nd the Jabra BT2010
• Your phone will nd the headset under name “Bluetooth headset”.
Your phone then asks if you want to pair with the headset. Accept by
pressing ‘Yes’ or ‘OK’ on the phone and conrm with the
passkey or PIN
= 0000 (4 zeros). Your phone will conrm when pairing is complete.
In case of unsuccessful pairing, put the Jabra BT2010 into
pairing mode
manually. Make sure the headset is o. Press and hold the answer/end
button for approximately 5 seconds until the LED has a constant light.The
LED will ash before the light is constant – keep holding down the button
until light is constant.
1 2
g 3