User Manual

5
ENGLISH
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1. Put the headset in pairing mode
- When you turn on your Jabra Talk 5 for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the LED is constantly lit.
2. Set your phone to ‘discover’ the Jabra Talk 5
- Follow your phone’s instruction guide. First make sure that
Bluetooth® is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going
to a ‘setup’, ‘connect’ or ‘
Bluetooth® ’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a device.*
3. Your phone will nd the Jabra Talk 5
- Your phone will nd the headset under name “Talk 5”. Your
phone then asks if you want to pair with the headset. Accept
by pressing ‘Yes’ or ‘OK’ on the phone and conrm with the
passkey or PIN = 0000 (4 zeros) if asked. Your phone will
conrm when pairing is complete.
Put the headset in pairing mode manually
In case of unsuccessful pairing, put the Jabra Talk 5 into pairing
mode manually. Make sure the headset is o. Press and hold the
answer/end button for approximately 5 seconds until the LED has
a constant light. The LED will ash before the light is constant –
keep holding down the button until light is constant. Then follow
the steps 2 and 3 above.
* Phone dependent