Operation Manual
5
ENGLISH
JABRA BT2045
Please note that the LED indicator light turns o after 1 minute to
save battery. Headset is still active, and light will ash again after
tap on the Answer/End button or any call activity. To check if the
headset is on, tap the answer/end button once – the LED indicator
light will ash, if the headset is on.
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1. Put the headset in pairing mode
- When you turn on your Jabra BT2045 for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the LED is constantly lit.
2. Set your phone to ‘discover’ the Jabra BT2045
- Follow your phone’s instruction guide. First make sure that
Bluetooth® is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going
to a ‘setup’, ‘connect’ or ‘Bluetooth® ’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a device.*
3. Your phone will nd the Jabra BT2045
- Your phone will nd the headset under name “BT2045”. Your
phone then asks if you want to pair with the headset. Accept
by pressing ‘Yes’ or ‘OK’ on the phone and conrm with the
passkey or PIN = 0000 (4 zeros) if asked. Your phone will
conrm when pairing is complete.
CONNECTIVITY
SELECT
MobilSurf
BLUETOOTH
Infrared port
Wap options
Synchronization
Networks
DEVICES FOUND
OK
Passkey:
****
HANDSFREE
SELECT
SELECT
Bluetooth Headset
Bluetooth
Headset is now
ready for use
Bluetooth Headset
* Phone dependent