Jabra BIZ 2400 User manual www.jabra.
© 2012 GN Netcom A/S. All Rights Reserved. This user guide is published by GN Netcom A/S. The information in this user guide is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by GN Netcom A/S. GN Netcom A/S assumes no responsibility or liability for any errors or inaccuracies that may appear in this user guide. Written and designed at GN Netcom A/S, Lautrupbjerg 7, 2750 Ballerup, Denmark, www.jabra.com.
connecting the headset to the phone: - Plug the headset into an adapter cord suited to your phone system - Unplug the handset from the phone* - Connect the adapter cord to the handset port *If your phone has a headset port, connect the adapter cord directly to the headset port.
English Thank you for buying a GN Netcom A/S product. All GN Netcom A/S products are designed and manufactured in accordance with strict quality standards and should, with a minimum of maintenance, give many years of satisfactory use. Wearing the Headset With the Headband All mono Jabra BIZTM 2400 models include a headband attachment. To use it: 1 2 cm 3/4" 2 1. How to wear the headband.
6 5. How to remove the headband Remove the ear cushion by gently pulling it off the ear-plate. Push on the inner part with your thumb until the headset clicks out of the headband. 6. How to press the headset into the headband ring on the headband. Hold the headband in one hand and the headset in the other. Align the headset against the outside of the headband ring with the headset cable pointing down. Gently press the headset into the headband ring until it clicks into place.
L R 3 3. How to position the ear hook on the ear hook ring for left or right ear use. The ear hook wearing style has two parts: an ear hook and an ear hook ring. One end of the ear hook forms a pin that presses into a loop on the ear hook ring and holds it there. You will wear the headset with the ear hook behind your ear and the ear hook opening pointing down towards your jaw. Decide on which ear you would like to wear the headset and assemble the ear hook and ear hook ring appropriately.
Wearing the Headset with the Neckband A neckband wearing style is included with some Jabra BIZ 2400 models. Neckbands can be purchased as an accessory for any mono Jabra BIZ 2400. To use it: 1 1. How to press the headset into the neckband ring. The neckband can be assembled for wearing on either the left or right ear. Decide whether you would like to wear your headset on your left or right ear and position the neckband ring appropriately.
2 cm 3/4" 5 4 6 4. How to wear the neckband. Wear the neckband so the band goes around the back of your neck and the bowed sections go over your right and left ear respectively, whilst the ear cushion sits on your ear. 5. Position the microphone. Adjust the microphone by rotating it around the headset and flexing the boom arm until it is positioned less than 2 cm from the front of your mouth. 6. How to rotate the boom arm. The boom is free to rotate 360o.
2 cm 3/4" 3 4 3. How to position the microphone. Adjust the microphone by rotating it around the headset and flexing the boom arm until it is positioned less than 2 cm from the front of your mouth. 4. How to rotate the boom arm. The boom is free to rotate 360o.
Dispose of the product according to local standards and regulations. www.jabra.
32-00681 F © 2012 GN Netcom A/S. All rights reserved. Jabra® is a registered trademark of GN Netcom A/S. All other trademarks included herein are the property of their respective owners. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by GN Netcom A/S is under license. (Design and specifications subject to change without notice). Made in China www.jabra.