DELUXE Model # SSMT1000 Item # 108709 © 2008 Tristar Products, Inc. All rights reserved. Distributed by: Tristar Products, Inc.
TABLE OF CONTENTS 3 4 5 6 8 9 10 2 Important Safety Information DELUXE Accessory Kit & Cookbook • "Recipes for Healthy Living" Cookbook • Power Juicer Platform • Filter Brush • Overflow Platform • Measuring Cup Helpful Hints Replacement Parts Kit #1 Replacement Parts Kit #2 Pulp Collector Filter Parts List Blade Lid with Pulp Guard Crescent Tool Assembly Pusher To order or for more information on juicing visit: www.powerjuicer.
TROUBLESHOOTING Problem The motor does not run after being switched on. Possible Reasons and Solution • Check to see if unit is plugged in. • Locking bar is not locked in place properly. • Check if all parts are assembled properly. The motor is running with loud noise and shaking. IMPORTANT SAFEGUARDS READ THESE SAFEGUARDS CAREFULLY BEFORE USING THIS PRODUCT! • NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid injury. This appliance is not a toy.
ADDITIONAL SAFEGUARDS The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will stop working temporarily until the Power Juicer cools down. Afterwards, the unit will continue to work again normally. In the event the Power Juicer is jammed the motor may shut down. If this occurs the juicer should be shut off and unplugged. The unit should be thoroughly cleaned to remove the obstruction.
DISASSEMBLY 1 Pusher IMPORTANT: Before disassembling the unit make sure you turn the power OFF and unplug the machine from the electrical outlet. PARTS LIST 2 MAIN UNIT (Fully Assembled) Locking Bar Pusher Pulp Guard Pulp Collector STEP 1: Remove pusher from the chute. 3 STEP 2: Lower the locking bar (silver) into position as shown. Lid with Pulp Guard 4 Chute Blade Filter Crescent Tool Pulp Collector STEP 3: Remove lid with pulp guard, and pulp collector.
ASSEMBLY 1 ASSEMBLY (CONT.) Assemble as shown STEP 5: 2 Base Locking Bar Lip Juice Spout Receptacle Base Front of Machine Place lid with pulp guard attached on top of receptacle, making certain it is snugly aligned with the pulp guard facing in the opposite direction of the juice spout. Lock lid into place by lifting locking bar up until it clicks into grooves located on both sides of the lid. Make sure locking bar is in the full upright, locked position.
