Operating Manual
POWER JUICER ELITE POWER JUICER ELITE Contents 4 5 6 7 10 11 13 14 Important Safety Information Helpful Hints Parts/Main Unit Assembly/Main Unit Assembly/E-Z Loader Attachment Disassembly/Main Unit Cleaning Your Power Juicer Troubleshooting Contents 3
POWER JUICER ELITE POWER JUICER ELITE Important Safety Information READ THESE SAFEGUARDS CAREFULLY BEFORE USING THIS PRODUCT! When using electrical appliances, basic safety precautions should always be followed including the following: • Always remove power cord from electrical outlet before assembly or disassembly. • NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid injury. This appliance is not a toy. • Consult your physician before giving fresh juice to children, especially infants.
POWER JUICER ELITE POWER JUICER ELITE Note: Refer to page 6 for all part names. Assembly Parts Main Unit Main Unit MAIN UNIT (Fully Assembled) Pusher STEP Filter 1: WARNING: Never plug the power cord into an electrical outlet before unit is fully assembled. Place base on a dry flat surface with locking bar in down position on the spout side in front of the machine (as shown).
POWER JUICER ELITE POWER JUICER ELITE Assembly Note: Refer to page 6 for all part names. Main Unit STEP POWER JUICER ELITE Assembly Note: Refer to page 6 for all part names. Main Unit 4: Place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the holes on the blade. Turn clockwise while holding the filter and receptacle in place until tight (as shown).
POWER JUICER ELITE POWER JUICER ELITE Note: Refer to page 6 for all part names. Assembly E-Z Loader Attachment Disassembly Main Unit Note: Refer to page 6 for all part names. 1: Important Safety Information STEP READ THESE SAFEGUARDS CAREFULLY BEFORE USING YOUR E-Z LOADER ATTACHMENT! WARNING: Before disassembling the unit make sure the power is OFF and remove power cord from the electrical outlet. Place unit on a dry, flat stable surface Remove pusher from chute.
POWER JUICER ELITE POWER JUICER ELITE Disassembly Main Unit Note: Refer to page 6 for all part names. Cleaning Your Power Juicer To Clean Main Unit: STEP 5: Use the crescent tool to remove the blade. Place the two pegs at either end of the crescent tool into the two holes on the blade. Press down and turn counterclockwise while holding filter and receptacle to unlock the blade. Remove blade carefully. STEP 6: Remove filter. • Turn off the power switch and wait until the motor completely stops.
POWER JUICER ELITE Exciting Offers from Power Juicer Elite Troubleshooting Problem The motor does not run after being switched on. Accessory Kit & Cookbook Possible Reasons and Solution • Check to see if unit is plugged in. Jack LaLanne’s Recipes for Healthy Living Cookbook Power Juicer Platform with Built-In Overflow Platform Measuring Cup Filter Brush • Locking bar is not locked in place properly. • Check if all parts are assembled properly.
© 2008 Tristar Products, Inc. All rights reserved. Distributed by: Tristar Products, Inc.
