Operating Manual

Assembly/Main Unit
7
STEP 2:
Place receptacle on the base, with
juicer spout facing the same direction
as locking bar. Settle receptacle
into alignment.
STEP 1:
WARNING: Never plug the
power cord into an electrical outlet
before unit is fully assembled
.
Place base on a dry flat surface with
locking bar in down position on
the spout side in front of the
machine (as shown).
STEP
3:
Place filter inside receptacle,
matching the opening on its
bottom to the screw peg
connected to the base.
Note: Refer to page
6 for all part names.
POWER JUICER ELITE
POWER JUICER ELITE
6
Parts/Main Unit
Lip
Chute
Screw Peg
Micro
Safetyswitch
MAIN UNIT
(Fully Assembled)
Receptacle
Removable
Non-Drip
Spout
Pegs
(Pegs fit into blade.)
Filter
Blade
E-Z Loader Attachment
with E-Z Plug
Lid with Pulp Guard
Pulp
Collector
Pusher
Crescent Tool
(for tightening and removing blade)
Base
Locking Bar
Assembly
Main Unit
Parts
Main Unit
Micro Reset Switch
WARNING: DO NOT OVER TIGHTEN)